Sharp Shoot R Maxx

Maxx™ Is the New Mil-Spec Lubricant for the U.S. Military

for All Small Arms including Fully Automatic Weapons

Maxximum Lubrication

Maxximum Corrosion Protection

Maxximum Moisture Protection

Maxximum Reduction of Friction

Shooters and outdoorsmen have problems unique to their particular sport. Firearms encounter explosive heat, grit, sand, corrosion, unburned powder residue, primer residue, carbon, minute metal fragments, and moisture as a routine part of normal use. Firearms also need to have long-term protection from rust and corrosion, as well as adequate lubrication.

How it works:

Maxx ™ is a cutting edge product. It contains a patented particulant contained in no other commercial lubricants. This use of this particulant is protected by a patent. One of the smallest particulants used in lubricants is molybdenum. The particulant in molybdenum is approximately 2 microns in diameter. Maxx™ contains a patented particulant that is spherical in structure, and is less than 1/20 th of a micron in diameter. The minute size of this particulant greatly decreases friction and drag by reducing greatly the build_up of heat. It puts an ultra_thin layer of spherical particulant and a high heat tolerant lubricant between metal parts. The small diameter of this particulant allows Maxx™ to penetrate in to the terrain of metal surfaces, which are less than 1/20 th of a micron deep. This particulant further carries with it a unique blend of synthetic non_petroleum low drag lubricant and high lubricity natural oils that sets up a boundary shield of lubrication.

Properties:

The characteristics of this natural/synthetic blend lubricant are quite unique, in that they have an operating range of +600º F down to _70º F.   Being a synthetic base lubricant, Maxx™ is non_gumming, and non_shellacing over any length of time. It does not change in viscosity or color, over time. Maxx™ contains no teflon or PTFE of any kind. These products have proven themselves to be gumming agents a which build up, and actually prevent lubrication to take place.

How to use Maxx ™:

Maxx™ works in a truly unique manner. It is applied in two or three applications after a thorough degreasing solvent is used. It is necessary to remove all evidence of other lubricants to make Maxx™ totally effective. Apply Maxx™ to a clean firearm and allow the volatiles to vaporize for 5 minutes or so. Apply a second application and repeat the drying procedure. This allows Maxx™ to build a coating over the metal of around 20 to 25 microns in thickness. It is this film that provides maximum lubrication while cutting friction to an absolute minimum. Maxx™ has proven itself superior in all the testing done by the U.S. Military and has been adopted as the lubricant for all small arms both semi-automatic and fully automatic.

Maxx™ has a neutral di-electric constant which allows the product to lubricate without attracting dirt and grit. Most lubricants are either positive or negative charged which is an attractant to dust particles. The neutral di-electric constant properties also allow Maxx™ to be used in any application where electric polarity is a concern.

Maxx™ is also a boon to users because if it’s moisture displacing qualities. Maxx™ will force moisture out of any metal or electrical parts and provide both lubrication and corrosion protection.

Maxx™ proved itself a superior anti-corrosion product in the testing done by the U.S. Military. A film of Maxx™ was put on metal parts to be tested, then a 5% solution of salt spray coated the test parts and the temperature was raised to 95 degrees. Maxx™ coated parts went for over 1000 hours with no rust or corrosion.